Techmatte

Select

S23U-TPU

Step #1:
Plug in the UV light to make sure it works properly.
Step #2:
Turn off your device and apply the leveling pads to the back of your phone. Clean the screen with the wet wipes and cleaning cloth.
Step #3:
Use the Screen-Prep cloth to wipe the surface of the screen a few times. Then use the cleaning cloth to clean the screen again. This will help to prevent bubbles during application.
Step #4:
Place the application tray on your phone. Make sure to align the side labelled " TOP" with the top of the phone. Press firmly into place. Then insert the pin on the application tray.
Step #5:
Adjust the application tray to make sure the 2 bubbles are in the center of each bubble level.
Step #6:
The application tray will be pre-installed with absorption pads to soak up any excess adhesive.
Please make sure they are securely installed on either side of the tray. Re-clean your screen using dust removal stickers if needed.
Step #7:
Unscrew the RED cap of the first adhesive tube. Hold the tube over one of the circle as indicated below.
Unscrewing the black cap will release the adhesive in the tube.
Step #8:
Drip all the adhesive onto the left side of the screen. Repeat step7 with the second adhesive tube. Apply the adhesive to the right side of the phone screen, aligning the tube with the pegs.
Step #9:
Peel off the mask film of the screen protector, and set it within the tray, resting one end on your phone screen and the other end on the pin. Make sure the camera cutout is aligned with the top of the phone, where the device's front-facing camera is located.
The protector should be suspended above the adhesive, resting on the pin.
Step #10:
SLOWLY pull the pin outward to allow the protector to lower on to the adhesive. Once the protector touches BOTH adhesive puddles, pull the pin out the rest of the way.
Step #11:
The adhesive will begin spreading on its own. While it is spreading. place the metal cylinder on the fingerprint scanner sticker.
Step #12:
Wait for the adhesive to fully spread to all edges of the phone.DO NOT TOUCH the screen protector during this time.
Step #13:
Plug in the UV light with your USBC cable, Place the UV light over the tray and device. Cure for about 15 seconds.
Step #14:
Remove the installation tray, metal cylinder and scanner sticker. Make note of STEP 15 below, as the timing for step15 is important.
Step #15:
Use the UV light again to cure about 75 seconds after step14 is completed.
Step #16:
Re-scan your fingerprints into the phone system if needed, and enjoy the screen protector!

Best Sellers

iPhone 15 Pro

iPhone 15 Pro Max

Galaxy S24

Galaxy S24 Ultra

iPad Mini 6

Nintendo Switch OLED